TWILIGHT SWITCH KEMO M197 12-28V/DC

Switches on any electrical load (e.g. incandescent lamp, motor, LED lamp or the like) at nightfall and switches it off again at daybreak.

Although the module is potted, it should nevertheless be installed in such a manner that it is protected against direct rain (e.g. below a roof overhang). Please make sure that the lamp, which is turned on by the twilight switch does not illuminate the twilight switch itself! Neither other lamps may illuminate the twilight switch as in this case it will not recognize when the twilight sets in! If you have the impression that the module turns on too late (approx. 45 Lux), you may shift the switching point and switch-off position by masking the crystal clear sensor partially with opaque adhesive tape.

It is only allowed to connect lamps or LEDs, which are approved for the tension you employ to operate the twilight switch (12 - 28 V). The maximum current consumption must not exceed 5 A.