ANTI MARTEN DEVICE SPLASH PROOF IP65 KEMO M180
May be mounted at the entrance holes of the cars. Through the water and dirt resistance, this Marten Device can be mounted on the cars initial openings directly.
*IP 65: No penetration of dust at a low pressure of 20 mbar in the case. Protected against hose-water from every direction against the case (corresponds to 12.5 ltr/minute - garden hose), (test period: 5 minutes).
If the device shall be applied against martens, it has to be mounted in the motor room or mounted at the car’s manholes of the marten. Please take care that there will be sufficient space in front of the direction of radiate of the device so that the ultrasonic sounds may extend widely in the motor room. The assembly and starting may only be carried out by competent persons who can also be held responsible for possible damage.
Ultrasonic sounds expand just like light, i.e. it is possible that they cannot act in all corners. If the motor room is strongly cleaved it may be necessary to mount various devices. Please try to adjust the direction of radiate in such a manner that the cables and tubes which are mainly endangered by martens will be irradiated directly by the marten-scarecrow. The device is splash-proof according to IP 65* and may, therefore, also be mounted at the vestibule openings at the bottom of the car. You should, however, pay attention that no layer of mud may settle on the appliance because this may impede the radiation of the ultrasonic sound.
After having connected the operating voltage of 12 V direct current, the LED which is installed in the device will flash. In case this control lamp does not flash slowly, there is either no electric tension or the polarity of the electric tension is wrong (positive and negative were exchanged).
Please consider that ultrasonic sounds do only represent a strong trouble for animals. Usually the animals will pass on to other vehicles where they will not be attacked through ultrasonic sounds. However, it cannot be guaranteed that martens will be expelled in every case.
Attention!
If the marten was already in your car and has placed its “scent marks”, washing of the motor is absolutely necessary. Also the road surface under the car should be cleaned with cleaning agents in order to remove the scent marks!
Please install in your car the anti marten device in a place where it cannot be overheated. Do not install it near the top of the car hood, nor close to the exhaust manifold or any other similar warm positions. The ideal positions are mostly on the back or in the front next to the radiator fan. Remember that if you install your device where it can receive > 80°C of heat, the life of it will be reduced dramatically!
- Operating voltage: 11 - 15 V/DC
- Average current consumption: < 2 mA
- Frequency: approx. 23 kHz
- Angle of radiation: approx. 160°, max. approx. 105 dB ± 20%, pulsating LED